Fluke 9010a Z80 pod bare pcb set
These are a pair of reproduction (not replica) boards for building a Z80(AA) pod.
They have been designed to closely match the original Fluke design although due to component availability limitations some changes have been made.
The boards are the same shape and size as the originals but with the following changes.
The 74ls374 buffer ic's have been replaced with much cheaper and easier to fine 74ls574 devices. These are identical parts except for the pin out (do not try to fit 74ls374).
The 60 way inter-board connector has been replaced by 3 20 way dual row connectors (see image) as the 60 way connector is practically impossible to find.
The power fail circuit has been redesigned as original Fluke custom devices are now non existent (The new design actually performs better than the old design).
I have fully tested these on actual computer hardware and all functions work 100%.
The position and type of connectors for all external leads are the same so an existing set of Fluke leads can be used if you have them.
Note that the Fluke custom output / input protection modules required to built these pods.
These are very high quality 4 layer gold plated boards and are ideal for anyone wishing to build or repair a Fluke 9010a Z80(AA) pod
With original pods selling for well over £1000.00 even if you can find one then building one from this set of boards is a very low cost alternative.
See a completed module being tested here:
https://www.youtube.com/watch?v=vT21GxlXYKY
Add this product to your cart below
under 'ordering options'.
|
